Lytening MR16 IC 2004ICV Low Voltage AirSeal Insulated Frame-In Kit

Designed for new construction where insulation will be installed around the fixture. Magnetic transformer is mounted inside housing for easy access. AirSeal complies with MEC and WSEC air leakage requirements. Pivoting bar-ends, pre-installed screws (or nails), and tool-free cable clamps for fast convenient installation of non-metallic Romex. UL listed for through wiring, mounting bars lock to T-bar ceiling runners without accessories. Installs in ceilings up to 1" thick, 3/8" integral plaster ceiling ring on 2004ICV.

Features:

*Trim and light bulb sold separately*

• Cut Out: 3-15/16"
• Width: 10-3/8"
• Length: 12-1/4"
• Housing: Aluminum. UL listed for direct contact with thermal insulation. AirSeal housing minimizes air leakage to less than 2 CFM at 1.57 PSF ( or 75pa), which complies with Model Energy Code and Washington State Energy Code and reduces heat loss and condensation in ceiling. Access door for inspection of junction box
• Mounting Frame: Aluminum. Accommodates ceilings up to 1" thick. 3/8" deep integral lip. Locks into position along length of mounting bars with locking screw and bendable slot. Four slots are position 90° apart to simplify alignment. Push-in/twist-out roto-clips hold reflector flush to ceiling
• Junction Box: Galvanized steel. Integral cable clamps permit attachment of non-metallic Romex cable without tools or additional connectors
• Mounting Bars: Galvanized steel. Bars pivot for easy attachment and wire-in below ceiling line. Bars extend to accommodate 16" to 24" O.C joist spacing. Bars can accommodate 12" O.C. joist spacing after a slight field modification. 2004ICV features integral self tapping philips screws for secure attachment to wood or metal construction. Attaches to T-bar ceiling without the need of accessories
• Socket Housing: Aluminum, with lamp adjustment assembly allows 35° max. vertical, 358° horizontal adjustment
• Socket: Field replaceable. Two pin socket
• Thermal Protector: Meets NEC and UL requirements. Integral to transformer. Located inside housing
• Transformer: Mounted inside housing, magnetic . 120V primary nominal 12V secondary. Removable from below

Model: 2004ICV